Neck length on 6 GT & 6x47 L ?

[Baddog 0302]

Seams what is on the internet is either two or three different diagrams, OR just leads you to a site selling the item.
I'm looking for the length of the case neck from the mouth of the case to the neck / shoulder junction.
Thank you

 

[Supersubes]

The lapua is .302” and the GT is .299. These are chamber lengths, not actual case lengths.

 

[Baddog 0302]

The lapua is .302” and the GT is .299. These are chamber lengths, not actual case lengths.

Thank you, BUT chamber lengths doesn't help with determining seating depths.
but probably a mute point, since the only Hornady 6 GT brass I've found is a 500 count lot.
AND, I've read to many bad post's about alpha brass.

 

[Supersubes]

Why would you use neck length to determine seating depth. Figuring a custom throat? Just curious.

 

[Baddog 0302]

Why would you use neck length to determine seating depth. Figuring a custom throat? Just curious.

Custom throat , you are correct. but, due to the lack of brass, as I stated above, I'm thinking about going with a 6 CM instead.
Con's of the 6 GT, no brass,over priced die sets, pro's; requires a very little amount of powder over what the 6CM requires to do the same job.