I just annealed my Win 308 brass after 3 firings. My bullets are seated a hair long to feed through my hinged floorplate magazine and the tip of the bullet hits the feed ramp. I cycled all the ammo throough the gun and 3 out of the 20 bullets had pushed back .025 further back into the case. I pulled on the tip of the bullet and was able to extract the bullet by hand. I ran them back through the neck sizer, re-loaded them, and was still able to pull the bullets out. The brass was annealed 6 seconds and shows no sign of being over-annealed, not blue or chared marks anywhere, they look just like Lapua brass that's new in the box. I am going to seat them .025 off the lands from now on so they don't hit the feed ramp, but did I over or under anneal these 3 cases?
