Neck turning .338LM
- Thread starter Gottschall
- Start date
Re: Neck turning .338LM
I have not done it yet. If I start getting brass that sucks I'll be turning the hell out of them.
I have not done it yet. If I start getting brass that sucks I'll be turning the hell out of them.
Re: Neck turning .338LM
I don't turn cases just to be turning cases. (Except on the BR rifle) But if measuring CLEAN cases (you really need to make sure the case necks inside are really clean) gets you .004" or more variation from thin to thick place on the case neck, it becomes a definite possibility. But I separate the "turnable" cases and compare. Unless you have several cases to work with, don't rush out and buy a lot of gear. Personally I wouldn't go through all the hassle and headache unless I had a minimum of 100 rounds that were needing turned.
I don't turn cases just to be turning cases. (Except on the BR rifle) But if measuring CLEAN cases (you really need to make sure the case necks inside are really clean) gets you .004" or more variation from thin to thick place on the case neck, it becomes a definite possibility. But I separate the "turnable" cases and compare. Unless you have several cases to work with, don't rush out and buy a lot of gear. Personally I wouldn't go through all the hassle and headache unless I had a minimum of 100 rounds that were needing turned.
Re: Neck turning .338LM
Don't have to in my TRG-42. I use the .365 Redding TiNi bushing and neck size ever couple of shots.
Chris
Don't have to in my TRG-42. I use the .365 Redding TiNi bushing and neck size ever couple of shots.
Chris
