I'm in WA, near Tacoma but I suppose I could send it off if the price is right and the smith capable of doing it properly. It's a Brownell's HBAR profile and it has flats where pins go (like notches cut out to make it flat for the drill). I have all the parts I just need it drilled and pinned and I need it done properly with the gas hole lined up.
Anybody on here that can do this for me for a good price? It's pretty simple but I don't do enough of 'em to warrant purchasing the jig to do it with.
I'd like the SS barrel blackened if you have the capabilities, or at the very least sand blasted to a lusterless gray like Noveske does their barrels.
If your price is works out with shipping to be on par with local I may go with one of you. Super simple turn around job if you have the gear.
Anybody on here that can do this for me for a good price? It's pretty simple but I don't do enough of 'em to warrant purchasing the jig to do it with.
I'd like the SS barrel blackened if you have the capabilities, or at the very least sand blasted to a lusterless gray like Noveske does their barrels.
If your price is works out with shipping to be on par with local I may go with one of you. Super simple turn around job if you have the gear.
