Need Help with B14R Trigger Issue

[Grand]

Just bought a couple of B14Rs and tried to put them in "drop-in stocks." Trigger pins are left-side proud and prevent action from fully seating into the stock. Tried drifting them over, but no joy - must be a tapered fit. What is the fix?

 

[srt-4_uk]

The pins are designed that way. Take one pin out and it will make sense. You either get different pins or relieve the stock.

 

[Grand]

Lousy design. So, pull the pins and grind them a few thousands shorter?

 

[Kisssofdeath]

Lousy design. So, pull the pins and grind them a few thousands shorter?

Probably so, what stocks are you using?

 

[AZ Dan]

Did you try installing them on the other side?

 

[srt-4_uk]

Lousy design. So, pull the pins and grind them a few thousands shorter?

Not a lousy design, just different.

 

[Trigger Monkey]

I just relieved the side of the stock a little.

 

[Grand]

I’ve got a Manners Mini-chassis, a McMillan, and an MDT. Rather than modifying multiple stocks, makes more since to trim the pins. Just wanted to make sure this was normal before I start grinding.