Rifle Scopes Nightforce Rings

[ivillarreal]

I have a 20MOA base and Remington Varmint contour barrel, will low NF rings work on 30mm tube and 50mm lens? Gonna order everything online just what y’all feed back before a gun shop sticks it to me. Lol

 

[loveha]

Yes, ish. I say it should work just fine because I used lows with an M24 contour and it gave me enough room, but barely. This was on a MPA BA 6.5 with a Athlon Ares BTR and NF low rings.

 

[Trigger Monkey]

I would bump it up to 1.0" rings to be on the safe side

 

[ofelas]

They will fit but the OP is better off buying a few different heights to determine the most comfortable objective height.

 

[deersniper]

Yes but may be close on bolt to ocular clearance.

 

[hafejd30]

Get the gun
Get the scope

Set scope on the gun and use coins or washers as spacers to determine desired height. Measure distance between top of picatinny and bottom of scope tube by measuring thickness of the coins/washers

Buy rings that fit your measurements based on their spec of this measurement or calculate distance to center of scope tube and do the same based on that measurement

 

[ivillarreal]

Get the gun
Get the scope

Set scope on the gun and use coins or washers as spacers to determine desired height. Measure distance between top of picatinny and bottom of scope tube by measuring thickness of the coins/washers

Buy rings that fit your measurements based on their spec of this measurement or calculate distance to center of scope tube and do the same based on that measurement

Thanks, was wondering how I could do some kind of measuring.