Official (DTA) SRS, HTI, Covert, Hunter Thread

[richthe1]

I have a 1.85” sico harvester big bore that it clears, but with less than 1mm. Not sure if it would contact under recoil. My 1.65” Diligent enticer S clears with like 4mm at the closest part. I’d say 1.75” cans and smaller will be no issue. The top rail is 0moa. No way to can’t or i would run out of clearence by the end of the rifle for the pic rail

Cool! I’ve got an OCL Hydrogen, so it sounds like that setup should work just fine.

It makes sense that with the larger diameter forend, 0 MOA would be easier to manage—you’d need the buttstock end of the top rail to be sky-high to accommodate 30 MOA. I could always swap back to the regular M2 if I want to shoot longer range and take advantage of the extra inclination.

Thanks again for the info!

 

[Jrtex]

Cool! I’ve got an OCL Hydrogen, so it sounds like that setup should work just fine.

It makes sense that with the larger diameter forend, 0 MOA would be easier to manage—you’d need the buttstock end of the top rail to be sky-high to accommodate 30 MOA. I could always swap back to the regular M2 if I want to shoot longer range and take advantage of the extra inclination.

Thanks again for the info!

Or just get a one peice 30 moa scope mount.

 

[richthe1]

Or just get a one peice 30 moa scope mount.

True, I just prefer a co-linear top rail so I can have the option to attach a clip-on on the same plane.

 

[Bambamoda]

Working on a gen 2 version of the oversized handguard. Removable one peice full length top rail to convert and A2 to an SRS-M2 with an integral suppressor.
This is a much larger handguard than my Gen 1. But it appears these are Likely going to be an aluminum handgaurd instead of carbon fiber for now. That could change.

Can you match or do better on the top rail tolerance of the DT? When I pace my starret on top of my rail the front of the rail isn’t close to the rear or the middle. This prob isn’t a big deal if but I dislike their machining.

 

[Jrtex]

Can you match or do better on the top rail tolerance of the DT? When I pace my starret on top of my rail the front of the rail isn’t close to the rear or the middle. This prob isn’t a big deal if but I dislike their machining.

Can you elaborate a bit on that?
Send me a PM.
I can send you a replacement, I’ve had a few with a couple issues, as you always have with any type of production. Seems to be some here and there.