Picture Request - M2008 in McM A4!

[mluning]

I've been searching for a few pictures of a Badger Ordnance M2008 in a McMillan A4 but haven't been able to find any.

I'm trying to see if someone out there has this setup or knows someone who does and is willing to put some pictures up on here.

I'm in the brainstorming stages of a new build...

B.O. M2008 (short action)
McM A4
B.O. M5

Can this be done?

Thanks guys,
Mike

 

[RADcustom]

Re: Picture Request - M2008 in McM A4!

I have only seen it mounted in three different stocks so far.
The AICS seems to be the most popular, the McMillan A5, and Terry Cross posted a pic of one in his Sentinel stock.

I would think your best bet would be to call McMillan and ask them if the A4 will work for that action.

 

[ShootToWin]

Re: Picture Request - M2008 in McM A4!

The badger 2008 will only work in the A5 due to its square tang.

 

[ChrisF]

Re: Picture Request - M2008 in McM A4!


Its also available in the McHale stock from McMillan , and the T4 from Manners .

 

[mluning]

Re: Picture Request - M2008 in McM A4!

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: ShootToWin</div><div class="ubbcode-body">The badger 2008 will only work in the A5 due to its square tang. </div></div>
Thanks for the reply ShootToWin, looks like I'll be headed another direction now..

I though the design of the M2008 action would be a nice complement to the A4 front end.

 

[SSG3K]

Re: Picture Request - M2008 in McM A4!

It will work in an A4 the rear tang will stick up and not be flush. I taked to Marty and Dick davis about this and both say it will work just fine. The only reason I didnt do it was the wait for the stock.

Rich