Accessories PM1440GT Lathe and full gunsmith setup

[pmhaddad]

Looking to sell my entire gunsmithing setup. Located in Newport TN.
A lot to list, and this is probably not comprehensive.

PM1440GT purchased new from PM July 2024. Like new, very low time on the machine. Includes DRO. Single Phase.
Tailstock DRO.
Through spindle coolant
Made tool holders and a shelf for the backsplash
Have 2 gal of oil, 1 gal of way oil, and 1 gal of coolant for it
True Bore Alignment System and Gator 6 jaw chuck
3 jaw and PM 4 jaw chucks
Spider for out board spindle
All the tooling for chambering and threading barrels
Mitutoyo micrometers
Starett machinist level
PTG reamer holder
Grizzly rods and SSG rods with full sets of pilot bushings
Dial indicators
Remaining barrel blanks

Really would like to sell as a package to someone vs. parting it all out. Don't particularly want to sell, but some unexpectedly high legal fees are forcing sale.
PM with any questions, happy to provide my phone number to serious potential buyers to discuss in detail, provide videos of it running, etc.

Looking for $20,000 for everything. Just the lathe is $14,500 new from PM, and you can get this basically brand new machine with no wait time.

 

[DeathBeforeDismount]

Damn Phil I wish I was closer! This is one hell of a setup for anyone looking into cutting barrels.

 

[pmhaddad]

Damn Phil I wish I was closer! This is one hell of a setup for anyone looking into cutting barrels.

I really don't want to sell it, but lawsuits aren't cheap

 

[Bigrederic]

Oh boy...

 

[Ruslow]

looked at the specs but dopes not say HPrating.What is the hp?Stan

 

[pmhaddad]

looked at the specs but dopes not say HPrating.What is the hp?Stan

2HP