PMC .45 ACP brass

[perazzisc3]

Anyone reloaded this brass??
Any good?
Please advise.

 

[UrbanSi]

Yep its great brass.

Pretty much as long as you are not reloading steel or AMERC you should be good.

PMC/RP/Speer/CBC/S&B... its all kind of the same, its not like rifle brass where you have bottom dollar
brass that is widely inconsistent, weight is all over the place and primer pockets loosen up after 3-5 loads.

Most pistol brass, especially a low pressure round like .45 ACP will last till you lose it. I have some .45 brass that has been loaded
15-20 times that hasn't split.

 

[milo 2.0]

Yep its great brass.

Pretty much as long as you are not reloading steel or AMERC you should be good.

PMC/RP/Speer/CBC/S&B... its all kind of the same, its not like rifle brass where you have bottom dollar
brass that is widely inconsistent, weight is all over the place and primer pockets loosen up after 3-5 loads.

Most pistol brass, especially a low pressure round like .45 ACP will last till you lose it. I have some .45 brass that has been loaded
15-20 times that hasn't split.

+1 on what urban says

 

[Silverbullet2]

PMC is good brass, I have been loading some of the same PMC brass for over 15 loadings. J

 

[perazzisc3]

Thanks for the intel!

 

[Pinecone]

I don't even track the number of reloads on most of my .45 brass. Just reload until the primer falls out or the case splits.