I just back from the range for zeroing and load work up since I just started reloading. I had a box of Horandy Match 168gr for zeroing all rounds feed and fired with no problems. After getting zeroed I wanted to test my first batch of reloads to see which powder charge worked best. The issue I noticed I had with reloads was it would take twice to fire them. I loaded the first round and fired nothing. Ejected round seen the primer had been struck. I decided to put it back in the gun and try again it fired. Almost all of the reloaded rounds where like this with the exception of two that fired on the first try. I am thinking maybe I didn't seat the primers deep enough? I also had one round that would not allow the bolt into battery. The bolt would close all the way but would not go down. All rounds were loaded at the same time with the same dies and no adjustment. It was all new unfired lapua brass with CCI primers and either 175 SMK or 155 scenars loaded over different charge weights of Varget. The rifle is a Gen 2 Badger M2008 I know the Gen 1s had the issue with light primer strikes I dont think that would be the issue do to not having any issues with the Factory loads. Any ideas what it could be so that I can learn for next time. Also one round would not fire what so ever.