Anyone have a print for inletting the short-action PTG Stealth bottom metal? It appears that the stock needs to be opened up quite a bit to accept it. Of course, I could map it myself but was wondering if anyone had already done this and would share the info.
This is going into a .223 rig. Any critical height measurement to be aware of or do I simply index off the top of the frame and then contour the top of the box to the receiver? Will I need to widen the rails of the receiver for the center-feed AICS mag?
I know, clear as mud right? If anyone can make sense out of what I wrote above and could provide some direction I’d appreciate it.
This is going into a .223 rig. Any critical height measurement to be aware of or do I simply index off the top of the frame and then contour the top of the box to the receiver? Will I need to widen the rails of the receiver for the center-feed AICS mag?
I know, clear as mud right? If anyone can make sense out of what I wrote above and could provide some direction I’d appreciate it.