• New Contest Starting Now! This Target Haunts Me

    Tell us about the one that got away, the flier that ruined your group, the zero that drifted, the shot you still see when you close your eyes. Winner will receive a free scope!

    Join contest

Rifle Scopes QD riser for T-1

patsim

Son of Liberty
Full Member
Minuteman
May 2, 2010
0
2
Southern Indiana
I want a QD mount that will allow an ACW with my flip-ups. Front sight post is right at 1.25" and the dot of the T-1 is about .75" in the factory mount (from the top of the mono-rail). So, I guess I need about .625" of riser. I don't see any listed with absolute heights. The ADM CAS-V looks about as close as anything. Any help or ideas?
 
Re: QD riser for T-1

Thanks for the help. I never did find the information for which I was searrching--the amount of rise, in inches, that any of these mounts affords. I went with the ADM T1-10.
 
Re: QD riser for T-1

According to Mark LaRue from a post on arfcom, the LT751 puts the optic centerline at 1.40" above the rail. In my experience, it is indeed an absolute co-witness with Troy flip-ups on an AR flat top. (The AD-T1-10 should be the same height.)

The LT660HK is reportedly 1.31", which would be too low for absolute co-witness with the same AR setup.