Hi all I am building a MAK tubegun need 2 reamers. 260 AI, and 243 AI. I do not want to go the neck turning route, so standard chambers, who's reamer would you use and why?
Andy
Andy
Gunsmithing Reamer advice
- Thread starter 762nato
- Start date
Re: Reamer advice
I use PTG reamers. If you need reasons why, just do a search here. You will find out why they are so popular, that and Dave is a great guy to deal with along with his staff.
I use PTG reamers. If you need reasons why, just do a search here. You will find out why they are so popular, that and Dave is a great guy to deal with along with his staff.
Re: Reamer advice
I would suggest calling the reamer maker of your choice and asking some questions, give them what you want, what bullet you want to shoot and see what they say.
When questions like this arise I usually call Mr. Kiff like mentioned above. The people at PTG can pull together a couple of prints in PDF form for you to look at and they'll email or fax them over.
You evaluate what you want, then give them the specs on it. I've done it numerous times.
I would suggest calling the reamer maker of your choice and asking some questions, give them what you want, what bullet you want to shoot and see what they say.
When questions like this arise I usually call Mr. Kiff like mentioned above. The people at PTG can pull together a couple of prints in PDF form for you to look at and they'll email or fax them over.
You evaluate what you want, then give them the specs on it. I've done it numerous times.
