I am looking to buy a torque wrench for my switch barrel M2008. What is the recommended torque spec and and suggestions for a quality torque wrench. Thanks.
Gunsmithing Recommended M2008 barrel torque spec?
- Thread starter david777
- Start date
Re: Recommended M2008 barrel torque spec?
Torque specs on the barrel are going to be what ever your smith used when setting headspace on your barrel when finish-chambering it. Usualy 100 ft-lbs.
I have a .308 barrel chambered and checked under 100 ft-lbs that I run a 50 ft-lbs. without a problem though.
Torque specs on the barrel are going to be what ever your smith used when setting headspace on your barrel when finish-chambering it. Usualy 100 ft-lbs.
I have a .308 barrel chambered and checked under 100 ft-lbs that I run a 50 ft-lbs. without a problem though.
