I have a rare day off tomorrow and was going to the range. I received my new batteries for my S&B 1-8x25 (CR2032) and popped it in. I store without any batteries in the device. I also tested the battery with a voltage meter and working as it should.
My scope has the 11 illumination settings. I get zero illumination at any setting. This was working just fine before putting it in my climate controlled safe. I tried contacting S&B support, but I just missed them. I've searched all over the net for info and came up short.
I'm sure my only hope here will be calling them tomorrow, but thought I would put this out there if anyone had comments or suggestions.
My scope has the 11 illumination settings. I get zero illumination at any setting. This was working just fine before putting it in my climate controlled safe. I tried contacting S&B support, but I just missed them. I've searched all over the net for info and came up short.
I'm sure my only hope here will be calling them tomorrow, but thought I would put this out there if anyone had comments or suggestions.
