Good afternoon, all,
This post is informational only in the event it helps anyone else. I spoke with HS Precision regarding their recommended torque spec and sequence of tightening with a Savage action and they gave me the following:
65 in-lb - front and rear action screw
hand tight - rear trigger guard screw
sequence - tighten both action screws, but start with the front (nearest muzzle) and make sure it is the first to reach final torque spec of 65 in-lb.
Not sure if this will be of much use to anyone, but I figured it was worth sharing.
Warmest regards,
Rob
This post is informational only in the event it helps anyone else. I spoke with HS Precision regarding their recommended torque spec and sequence of tightening with a Savage action and they gave me the following:
65 in-lb - front and rear action screw
hand tight - rear trigger guard screw
sequence - tighten both action screws, but start with the front (nearest muzzle) and make sure it is the first to reach final torque spec of 65 in-lb.
Not sure if this will be of much use to anyone, but I figured it was worth sharing.
Warmest regards,
Rob