i"m wondering if i can put the knob in a vice, heat it up and bend it back towards the rear of the gun so it can make contact with my first knuckle,for easier cycleing. or will the heat make it to brittle after? thank you in advance.
Gunsmithing savage large boltknob
- Thread starter heavy boolitt
- Start date
Re: savage large boltknob
There is a little more to bending a bolt handle than that.You need to protect the bolt from heat to save it's temper often a heat sink is made to screw into the bolt to protect the cocking cam and strength of the threads.Any polished surface will carbonize and pit unless they are covered with some sort of protectant once the bolt handle is hot enough it will bend with a few whack's of a rawhide hammer or mallet of your choice.Look up De-carburizing paint or heat stop paste.
There is a little more to bending a bolt handle than that.You need to protect the bolt from heat to save it's temper often a heat sink is made to screw into the bolt to protect the cocking cam and strength of the threads.Any polished surface will carbonize and pit unless they are covered with some sort of protectant once the bolt handle is hot enough it will bend with a few whack's of a rawhide hammer or mallet of your choice.Look up De-carburizing paint or heat stop paste.
Re: savage large boltknob
except that a Savage bolt handle is rmovable.... I'd heat it just enough to bend it, then cool is slowly.... oven or oil
except that a Savage bolt handle is rmovable.... I'd heat it just enough to bend it, then cool is slowly.... oven or oil
Re: savage large boltknob
Is that knob CAST? If so, it might brake.
Is that knob CAST? If so, it might brake.
Re: savage large boltknob
idont know if it is cast. got it though midway usa.
idont know if it is cast. got it though midway usa.
