Gunsmithing Seekins And CDI Inlet

[GO-FASTER]

anyone know if these are the same inlet?
if not the same what one is wider

 

[sobrbiker883]

Re: Seekins And CDI Inlet

educated guess-
no

Nothing a mill/dremel and some Devcon/coating couldn't make work however.....

 

[chpprguy]

Re: Seekins And CDI Inlet

It has been my experience that if you email them, they will send you the dimensions via a drawing......

 

[Glen Seekins]

Re: Seekins And CDI Inlet

definetly not the same. As different as night and day.

If you look on my website i have some inlet drawings in PDF form
these are drawings of our original DBM that uses our mags.

Our new AICS kit is 1.20" wide at the mag well area.
Front and rear tang area (where the screws go) is .62" wide, same as factory BDL, just needs to be a bit deeper.

Out mag system is easily inlet with a manual mill. A 3/8 cutter around the mag box and a 5/8 to do the tang areas is all thats needed. Nice strait cuts