I (well, my department) have a LRS1 Blaser and when I shot it this weekend I had an issue with rounds hanging up short of the chamber. I eventually figured out the rounds were popping up to feed but were jumping up over top of the ejector. The ejector is a spring plunger with a small rounded head tip that screws into the spring guide. The head had apparently unscrewed a turn or two and the rim was catching behind the flange of the head. I was able to screw the head back down a bit with my finger and it feeds now but I'm concerned with how to prevent it from happening again. Anyone experience this issue and/or have a remedy?
Sig/Blaser LRS1 ejector issue
- Thread starter gunnut284
- Start date
-
- Tags
- ejector issue lrs1 sig or blaser
Re: Sig/Blaser LRS1 ejector issue
There isn't any slot or allen hole or any other way to tighten it down.
There isn't any slot or allen hole or any other way to tighten it down.
