Rifle Scopes Simmons 6-21x mil-dot calibration
- Thread starter sscoyote
- Start date
Re: Simmons 6-21x mil-dot calibration
Measure out and mark 36" at 100yds. Adjust the magnification until it's exactly 10mils on the reticle. That's going to be where it mils.
I don't care what kind of scope it is and what the manual states. Always verify at the range.
Measure out and mark 36" at 100yds. Adjust the magnification until it's exactly 10mils on the reticle. That's going to be where it mils.
I don't care what kind of scope it is and what the manual states. Always verify at the range.
Re: Simmons 6-21x mil-dot calibration
Appreciate the info BB, but i need to know if the mil is "rough-cald" at a power less than the highest so it can be applied at a higher power and smaller subtension. I would also like to know if they use a base-ten mil at .2 mil for the dot or if it's a 0.125 system.
Appreciate the info BB, but i need to know if the mil is "rough-cald" at a power less than the highest so it can be applied at a higher power and smaller subtension. I would also like to know if they use a base-ten mil at .2 mil for the dot or if it's a 0.125 system.
Similar threads
