Selling my two custom Harris bipods since I'm getting out of LR shooting.
These are made by cannibalizing two Harris Bipods to make each one. You end up with a 7-12" bipod which is low enough for bench shooting (9-13" is just too tall) but goes up high enough for field shooting especially if you need to shoot on a downhill slope. They start as a 9-13" swiveling notched leg bipod and the outer posts are shortened, spring perches relocated, and then springs from a 6-9" and spring posts (where they hook on top) are used.
Both bipods are swiveling with notched legs and have the RRS HC-Pro clamps that attach to both Picatinny and Arca Swiss plus Hawk Hill Talon feet (the dirt is free), and KMW pod locs.
Each bipod uses $175 worth of bipods to get the parts, plus another $175 for the HHC, RRS, and KMW parts for a grand total of $350 into each bipod plus a few hours labor.
I'll sell them for $275 each FIRM or $525 shipped for both.
These are made by cannibalizing two Harris Bipods to make each one. You end up with a 7-12" bipod which is low enough for bench shooting (9-13" is just too tall) but goes up high enough for field shooting especially if you need to shoot on a downhill slope. They start as a 9-13" swiveling notched leg bipod and the outer posts are shortened, spring perches relocated, and then springs from a 6-9" and spring posts (where they hook on top) are used.
Both bipods are swiveling with notched legs and have the RRS HC-Pro clamps that attach to both Picatinny and Arca Swiss plus Hawk Hill Talon feet (the dirt is free), and KMW pod locs.
Each bipod uses $175 worth of bipods to get the parts, plus another $175 for the HHC, RRS, and KMW parts for a grand total of $350 into each bipod plus a few hours labor.
I'll sell them for $275 each FIRM or $525 shipped for both.
Last edited:
