Specwar Trifecta flash hider problem

[Bigbuckeye]

Guys,

I recently purchased my first Suppressor, a Specwar 762 for my SCAR 17s and 700 AAC SD. I am trying to mount the flashhider on the 700 and there is not enough area between the flashhider and barrel to fit a box wrench.

Any ideas how I can tighten this down?

 

[Rstrick0352]

Stick something through the ports (I use an old aluminum car antenna, being that it's softer than the steel). A decent quality wooden dowel would work too.

 

[Donr13]

I have the same problem with mine. I used a different wrench.

 

[Bigbuckeye]

Stick something through the ports (I use an old aluminum car antenna, being that it's softer than the steel). A decent quality wooden dowel would work too.

That was my first thought....but I wanted to check first.

I checked all of my wrenches and none of mine will work.

 

[BurnOut]

You can use the dowel method, or shave down a cheapy box end wrench, or purchase the "correct" tool from Silenerco: http://www.store.silencerco.com/collections/center-fire-rifle/products/replacement-saker-tool

One thing that I have to give AAC is that they sell a tool to install/remove their three prong flash hiders...

 

[Buckeye308]

I have the Saker tools and work in Delaware, Ohio. Send me a pm and I will get you the tools to put it on.

 

[Bigbuckeye]

Thanks guys, I like the correct tool for the job so I ordered the Silencerco tool.