Looking to have a proof carbon fiber stock cut down to shorten the lop. No idea on where to send it. Anyone know anybody that could do this type of Work? Thanks
Gunsmithing Stock lop modification
- Thread starter JohnDeereGuy1996
- Start date
Oh shit! Hope he is ok / getting better.
He knocked out a KMW install on my McM A5. Super cool dood.
He knocked out a KMW install on my McM A5. Super cool dood.
At one time at least, ag composites made the stocks, may be worth asking them if there are any special considerations that might be needed? Not sure that’s the case anymore
I havent worked with that specific stock, but I've run into many of the "lightweight fills" that are essentially hollow in the stock area.
^ this is great advice. It would be good to know what's in there before you start chopping. You'll need material to glue or glue & screw the new recoil pad into.
