Suppressors supressor causing excess pressure?

[levi8599]

I have an SAS resistor mx and when I run it on my 6.5cm gas gun it's blowing primers, hard ejector swipes and even bending case heads? This load had no pressure signs without the can and even adjusting the gas down just enough to get it to cycle the next round is causing problems. Anyone else have this issue? Do I need to dial back the load?

 

[culater]

Give us your load data

 

[demolitionman]

I just crossed paths with another thread on here the same thing going on, they hashed it out really well.....ill see i I can link it.

 

[agbm]

Check out this post, https://www.snipershide.com/shootin...de-suppressors/6538468-one-for-the-think-tank

 

[levi8599]

41.5gr h4350
140eldm
hornady 1x fired brass
fgmm 210m

 

[levi8599]

Check out this post, https://www.snipershide.com/shootin...de-suppressors/6538468-one-for-the-think-tank

Thx. Maybe a heavier buffer sounds like