I'm looking at picking up a stock and it's inlet for the Surgeon DBM. Do any of the cheaper DBM setups use the same inlet?
Thanks,
Dan
Thanks,
Dan
Gunsmithing Surgeon inlet...any other DBMs work?
- Thread starter clark98ut
- Start date
Re: Surgeon inlet...any other DBMs work?
I do believe Surgeon, Badger, APA, Seekings, Defiance will fit the same inlet. CDI is different and Hooper Ordnance is different that I know of.
I do believe Surgeon, Badger, APA, Seekings, Defiance will fit the same inlet. CDI is different and Hooper Ordnance is different that I know of.
Re: Surgeon inlet...any other DBMs work?
Atlasworxs are different too. A lot tighter in the corners between the trigger guard and the mag box. You can see the difference in the picture here:
http://atlasworxs.com/cart/index.php?act=viewProd&productId=16
Atlasworxs are different too. A lot tighter in the corners between the trigger guard and the mag box. You can see the difference in the picture here:
http://atlasworxs.com/cart/index.php?act=viewProd&productId=16
Re: Surgeon inlet...any other DBMs work?
Having installed all of the above mentioned I can tell you that they are all different.
They may physically install into your stock depending on how much stuff is blown out, but I have had to write individual programs to fit each mentioned.
The primary issue becomes the tangent points on the arcs that tie in the box portion to the front screw and how it transitions to the rear bow. There's also variances in how wide the rear bow gets made. They range from .625" to over .700" in width.
C.
Having installed all of the above mentioned I can tell you that they are all different.
They may physically install into your stock depending on how much stuff is blown out, but I have had to write individual programs to fit each mentioned.
The primary issue becomes the tangent points on the arcs that tie in the box portion to the front screw and how it transitions to the rear bow. There's also variances in how wide the rear bow gets made. They range from .625" to over .700" in width.
C.
Re: Surgeon inlet...any other DBMs work?
The Surgeon DBM is good shit. I don't think you'll save a whole lot going with something else.
The Surgeon DBM is good shit. I don't think you'll save a whole lot going with something else.
