Rifle Scopes Tangent Theta tool less zero question

[canezach]

So, I finally bit the bullet and ordered a TT525P, so I have what is probably a very simple question/questions about the tool-less rezero and zero stop.

1. I understand setting zero is as simple as zeroing, unlocking the turret, setting the turret back to 0, and tightening down the turret lock. Is the zero stop always at a certain position? Like is it always 0, 4 clicks below zero, whatever?

2. Piggybacking off 1, since it's going on an AI AX, if I need to go below 0 when swapping calibers, let's say I'm zeroed for 6.5 Creedmoor but 6XC is -0.5, is it as simple as loosening the turret, dialing to 0.5 mills, and tightening the turret so 0 will now be 0.5 below my previous?

 

[dirthead1]

1. Yes, the zero stop is always below zero (mine is .6 below).

2. Yes, that’s is exactly how you would handle an offset when swapping barrels in your AX.

 

[chrome]

So, I finally bit the bullet and ordered a TT525P, so I have what is probably a very simple question/questions about the tool-less rezero and zero stop.

1. I understand setting zero is as simple as zeroing, unlocking the turret, setting the turret back to 0, and tightening down the turret lock. Is the zero stop always at a certain position? Like is it always 0, 4 clicks below zero, whatever?

2. Piggybacking off 1, since it's going on an AI AX, if I need to go below 0 when swapping calibers, let's say I'm zeroed for 6.5 Creedmoor but 6XC is -0.5, is it as simple as loosening the turret, dialing to 0.5 mills, and tightening the turret so 0 will now be 0.5 below my previous?

Just zero'd my TT for the first time earlier this week (6.5cm and .223), and did exactly this as mentioned above. Enjoy!

 

[Dthomas3523]

Yep, it’s that easy.

My gen3xr is .7 below.

 

[Campt413]

Interesting the difference in zero stop. Mine is .5 below. 315P

 

[Feif64]

I dont know where my zero stop is but, I just zeroed my 525 A few weeks ago and dam is that thing sexy.

 

[canezach]

Mine arrived this afternoon, so I got to play with it for about 30 seconds. My zero stop is 0.7 mil below 0, so I have 6 clicks

 

[-Time-]

Interesting. My 525P is .5 below. To answer your 2nd question though, yup. If your zero for another barrel is -0.5mils, simply dial -0.5, loosen the turret, lift and turn to zero, then tighten the turret back.

 

[blbennett1288]

Mine was 0.7 below zero