Tikka Master Sporter in .308, question about adjusting stock and mounting bipod.

[want2learn]

Hi, I recently acquired a Tikka Master Sporter in .308 Winchester. Looks like a nice rifle, just mounted a scope to it after purchasing the Optilock rings.

The rifle came with no paperwork so i called Beretta but they only had a generic sheet that didn't really show the specifics of that model's stock adjustments.

I was wondering if the comb is adjustable for right and left or only up and down. Also are the buttstock spacers adjustable for can't/twist? If so what type of tool would you use to remove the spacer/recoil pad...i can see little holes but don't know what to try (a screw driver, a hex key etc), don't want to bugger up the pad, they're pretty small holes. And one last question, how does one mount a bipod to the European (Anschutz?)type rail.

Thank you

 

[beenjammin]

Harris does make a bipod adapter stud #6 for the euro rails. It's about 15 bucks. I had a couple of these master sporters and the check is just up and down. I never messes with length of pull and left mine in factory config

 

[beenjammin]

I wanna say accushot had a pic rail adapter for an atlas but not 100% certain

 

[want2learn]

thank you...i'll check. appreciate all the help and info

 

[jet_lagged]

You can get the full Accu-Shot BT28 AFAR Picatinny Accessory Rail Section Kit, or you can get one of these metal pieces to slide into the rail and then screw a sling stud into it.

http://www.ebay.com/itm/Atlas-BT28N...213600?hash=item2824919960:g:CbIAAOSw8d5ZQbdT

 

[Tikka595II]

The screws are hex key 5/32 I believe once you loosen them it slide side to side and when you remove it you will find another hex bolt underneath which when loosened allows you to pivot left to right as well. Pics coming

 

[Tikka595II]

i found the magpul MOE rails also fit

 

[want2learn]

Wow thank you all so very much, it helps tremendously. appreciate all the time and effort. Can't wait to really learn this platform. Going to work up some loads tonight