Gunsmithing Tikka t3 lite synthetic stock flush cup install

[SPAK]

Can jb weld can be used to epoxy flush cups into a factory tikka t3 lite stock? I have a feeling it won't stick but was hoping someone could tell me otherwise..

if not is there an epoxy that can be used on plastic stocks reliably?

thanks...

 

[sortafast]

Some plastics just don't play well with most epoxies. I mean, you can always give it a try. If there is enough meat where you are wanting to put the cup, you can go with the thread in kind of flush cups and epoxy them in for the double whammy to hold it. At least the threads might give it a little more strength when pulled on. But you'd have to buy the tap, the drill and have some sort of machine (drill press or mill) to drill it. Hand drilling a hole you intend to tap doesn't always go well especially in plastic. Hope this helps.