Trg mag in a T3X?

[LeoSD]

Looking for any information on how to run a better mag in a long action t3x. Planning on putting on a 6.5 prc barrel, so I think ideally id like a trg-42 mag. I have a ctr and like that setup, but as far as I can tell they dont make a long action version.

Anyone know of a bottom metal that would make this work? I may have to go aics, but id prefer not to.

 

[Blueoval56]

Pretty no one makes a bottom metal for a tikka that accepts a TRG-42 mag.

Your best bet is a bottom metal that accepts the MDT 3.560” magazine. There are companies that make bottom metals that accept the 3.715” mag but you won’t be able load any longer than the 3.47” oal length that the 3.560” magazine allows due to the limits of the action. But if it’s a short mag like the 6.5PRC then it shouldn’t matter.

 

[beetroot]

Why do you want to use TRG magazines?
AICS will be far easier and cheaper (unless you already have TRG magazines).

 

[LeoSD]

Why do you want to use TRG magazines?
AICS will be far easier and cheaper (unless you already have TRG magazines).

Maybe I just need to learn how to adjust them better, but I've had struggles feeding with aics

I have a ctr which uses basically cheap trg mags and have owned a trg both of which I like

 

[LeoSD]

What did the trg-s use?

 

[Blueoval56]

What did the trg-s use?

It used basically a cut down version of the TRG-42 mag to sit flush with the stock, but it was retained in a different position.

Short action AICS mags can be a pain to get the lips to feed right with certain cartridges, but I’ve never had a problem with long action AICS mags, always fed pretty well.

 

[LeoSD]

May end up going that route, thanks for the info

 

[R3nd3r]

The AICS mag should be affordable man and it's better.