Trigger Tech Special Issue

[elmuzzlebreak]

Unfortunately I cannot post a video but two things going on.

1. Firing pin cocked, rifle on safe, pulling the trigger causes the shoe to stick to the rear. Moving the Selector from safe to fire causes the firing pin to be released.
Removed the barrelled action and trigger. Reset everything. That problem goes away.

2. selector switch on safe, pulling the trigger causes the selector to jump to fire.

this action sits in a KRG.

 

[Hollywood 6mm]

What action are you using?

 

[B y r o n]

Have you checked to see if your trigger is part of the recall?

 

[Northernjets]

What action are you using?

This. My Nukes both needed a bit of material removed from around the safety cut out on the KRG backbone to properly fit in both my Bravo and W3. Is the safety making full travel?

 

[elmuzzlebreak]

What action are you using?

Using an axiom in a whisky 3. I also have the same kind of trigger in my Impact/Whisky 3 rifle no issues.

Have you checked to see if your trigger is part of the recall?

I have no idea there was a recall but I will check it.

 

[Krob95]

On the KRG stocks, you may have to relieve a little material so that the safety can fully engage as there’s just enough material there to keep it from fully engaging. Pull the BA and try the safety. If it functions correctly, your issue and solution is in the first sentence.

 

[AlpineSniper]

Thats interesting. First I've heard of that happening. Wasn't aware that there was a recall.