Rifle Scopes Weaver Grandslam Tactical Issues

Nosler243Shooter

Sergeant
Full Member
Minuteman
Mar 31, 2010
437
6
40
Alabama
After zeroing the scope I zeroed the turret. When I set the turret back down the lines on it didn't line up with the lines on the scope. I didn't notice this issue until I pulled the turret off and zeroed it. Could a different oring help this issue or do I need to return the scope?
 
Re: Weaver Grandslam Tactical Issues

Try to float the caps again and see if you can move it one spline either way. Maybe, it is off but just remember which side of zero you are on and drive on.

Good luck

Jerry
 
Re: Weaver Grandslam Tactical Issues

It's probably off a half tick mark because the turret lines were indexed when it was on the shaft.Once you re-indexed it sadly they don't line up...they MAY replace it with another cap if you ask them and that may solve it.Personally I wouldn't worry about it as they're just reference marks anyway.