Gunsmithing welder needed....aics mag

[B.Bates]

Guys,


I am in need of a good welder to weld up the 2 holes in my aics mag i modded for my 7wsm.

i originally used jb weld to plug the holes, however after a month of shooting it didnt work out.

most of the guys i know that weld around here, arent that precise and dont want to mess with such a small job

i have 2 mags and need someone to weld up the holes in them

thanks for any suggestions.

benjie

 

[19Scout77]

Re: welder needed....aics mag

Hey B- Nice meeting you at ASC! Check with a buddy at a body shop. Any one who can weld a panel shout be able to plug them. Ideally you want a tig welder.

If you cannot find one local shoot me a PM and I'll get you taken care of.

Eric

 

[JRose]

Re: welder needed....aics mag

If you have trouble finding someone to do them, I'll plug them for you. It only takes a couple minutes if you've already drilled the plate out.

 

[JRose]

Re: welder needed....aics mag

BTW, there's not much precision to a couple of plug welds, I just hit them with my MIG and a grinder...

 

[B.Bates]

Re: welder needed....aics mag

Jrose is going to take care of me


Thanks again

 

[john4jackson]

Re: welder needed....aics mag

i dont know if you have found your welder yet but i can fill your holes for you.. I have been a welder for 6 years im a supervisro of a weld shop and as one of the other post says a body shop guy would be a good bet well im a wyo tech grad if that makes you feel better and i also do tig welding and painting for gap and 30calsniper if you know who that is. if your interested let me know.

 

[JRose]

Re: welder needed....aics mag

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: jgunner</div><div class="ubbcode-body"> i can fill your holes for you.. </div></div>


Sorry... I had to quote that....

 

[hexades1]

Re: welder needed....aics mag

How long will the AI mag internal OAL be without the plate ?

What about the AWM 338LM mag, would it benefit too from similar treatment ?

 

[USMCj]

Re: welder needed....aics mag

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: TA</div><div class="ubbcode-body">How long will the AI mag internal OAL be without the plate ?

What about the AWM 338LM mag, would it benefit too from similar treatment ? </div></div>

2.985" IIRC.