• New Contest Starting Now! This Target Haunts Me

    Tell us about the one that got away, the flier that ruined your group, the zero that drifted, the shot you still see when you close your eyes. Winner will receive a free scope!

    Join contest

What a Difference a Grain Makes

Flatbush Harry

Sergeant of the Hide
Full Member
Minuteman
Jun 18, 2011
224
26
78
Colorado
I went to the range every day for the last 4 days and will go again today, in all likelihood. On Monday, I was looking to square away my Winny M70 EW in .30-06 for a possible upcoming hunt.

Just to warm up, I had brought a few of my standard M1 Garand match loads (47.0 gr of IMR4895 under a 168gr Sierra MatckKing with CCI BR2 primer) to see how the rifle would handle them and also get some sense of its 100-yard zero with a 168gr bullet. I was more than a little disappointed with my first 6 shots:

sc018f1010_zps248ed6bf.jpg


I happened to have a few remaining cartridges from a test session I had with my Savage 116 last year, so next I tried 5 shots with a slightly different load. The only difference in this load was 1.0 gr more of powder (total of 48.0gr), specifically IMR4895, which is my standard powder for my M1s:

sc018f699a_zps83309db4.jpg


This second group measured 0.6" ctc. Now I'll be working with several 168gr hunting bullets to find the best loads but I think, for a hunting rifle with no modifications but a scope, this Winny isn't too bad. I find the improvement from one grain of powder interesting and will be truing loads 1/2 gr heavier and lighter than this one to see if there's any difference.

BTW, these two groups were shot about 15 minutes apart after the barrel had cooled so I can't attribute the differences to just cold v. hot barrel.

FH



 
Re: What a Difference a Grain Makes

Very interesting! I'm still pretty new to hand loading, but so far I've noticed that even a few 10ths of a grain can make a difference, maybe 2/10 or 4/10 gr. can make or break a load.

Still trying to match the Federal GMM ammo/168 gr. Sierra HPBT... getting close.
 
Re: What a Difference a Grain Makes

In handloading... a grain can make a massive difference.

Run the loads too fast, and you get patterns, not groups. Run too slow and the same applies with massive drop. This is why it's a good idea to test handloads upwards until accuracy drops off, then back off a bit. Lots of info on this in the handloaders section.

Great pictures showing a hot load vs. a slightly milder load that demonstrates accuracy vs. velocity. Thanks for posting.

Cheers,

Sirhr