What Angle Cosine Indicator mount for a DTA HTI?

[secondofangle]

I tried to pirate a Badger Ordnance ACI from a Rem 40-X Short Action (7mm Mag) on a badger base and put it on my DTA HTI and it will not clear the chassis. Anybody know if there is an ACI mount that will fit the rail on a DTA and clear the chassis?

 

[jdr724]

Did you try the gen 1 or gen 2 badger mount?

ACI's & Mounts - Sniper Tools Design Co - Home of the Angle Cosine Indicator

 

[VKC]

It's the curve of the mount that does not clear the rails. Remove the polymer skins and insert it onto the bare chassis from the back.


Sent from my iPad using Tapatalk

 

[secondofangle]

It's the curve of the mount that does not clear the rails. Remove the polymer skins and insert it onto the bare chassis from the back.


Sent from my iPad using Tapatalk

Correct, the curve won't clear the chassis the latter is too fat much fatter than a 700 action.

Don't know if gen 1 or gen 2 I'll check when I get home, does gen 2 stick out further from the rail?

 

[VKC]

The one I have is a gen2, no problem fitting it after removing skins


Sent from my iPad using Tapatalk