What can I do to pull .408 bullets from a loaded round (Cheytac)

[VaRandy]

I have the RCBS bullet puller but no proper collate ( had to use the .41 pistol one) Total failure!) I don't think there is a connect that big.I have the large RCBS press but have nothing to go with it to help with this problem,

Does anyone make a proper tool for this job.

 

[No1]

How many do you have to disassemble? Have you tried impact puller? If the proper collet isn't available or one a little smaller won't work... you can push the round up through the press and grab the bullet with vise grips and then retract the ram.
Hornady and Forster make pullers too.

 

[VaRandy]

I am unaware of an impact puller large enough.

I have a RCBS puller but no collet the right size. I suspect there is the same problem wit the Hornady and Forster. I don't think my forster will open up enough to hod the case. There has got to be someone in the .408 world that has had this problem!

 

[Pahntr760]

Grip-n-Pull The World's Best Bullet Puller

 

[J.J. Kelly]

I have a regular bullet puller and tried to pull bullets from a .338 lapua. I found out
the case was too big to fit in bullet puller. So by not using the screw on cap or shell
holder; I just stuck it in and hit the floor. After 3 or 4 hits bullet was pulled, however
case was stuck in plastic bullet puller. To get it out, I put it over RCBS press and slid
the shell holder into ram and the same time over the case. Now by pushing handle
up, the top of press held bullet puller as the ram removed case. Try and make a "T"
handle tool to fit the .408 or maybe hollow out a bullet puller, then smack the floor.

 

[mdmp5]

Try the Lyman magnum kinetic puller. It fits 338 pretty easily, it may fit a 408

 

[07yzryder]

i took a cheapo kinetic puller and some crap brass for my 338. i torched the brass and pushed it into the puller which formed the chamber to the proper size. did this a few times to get it a bit smoother. Then i take the case holder put it on the case and drop it into the puller screw the cap on and voila works perfect.

Not sure how much bigger the 408 is but just thought i would throw it out there.

 

[hessian]

I got a Hornady collet puller from Sinclair. Works great. My Jamison ammo is about 15% duds so I pull'em and reprime with 215MM's.This is not a Sinclair recommendation.