Where did all the Bartlien 6mm 7twist M24s go??

[Diver160651]

I didn’t buy enough anyone have a lead on a fresh one?

 

[schmi015]

snag a gain twist https://www.altusshooting.com/products/bartlein-gain-twist-barrels

 

[Diver160651]

snag a gain twist https://www.altusshooting.com/products/bartlein-gain-twist-barrels

Thanks but if I cut to 24” not sure what it ends up??

 

[Diver160651]

Thank you to @Rodney_6 !!!!!!

I think I got a couple

 

[b6graham]

Thanks but if I cut to 24” not sure what it ends up??

7.06 roughly i calculated

 

[Diver160651]

7.06 roughly i calculated

that’s to damn slow !!

Impress calculations- thanks

Top line, Kidding of course found the same ones I am using .. trying to stay away from much load dev etc..

 

[b6graham]

i just took .7" twist over 26" finish length. found out twist per inch. then subtracted 2" to make it a 24"

 

[schmi015]

eh cut the extra off from the bore side, you'd still have a 7 twist at the muzzle

 

[Diver160651]

eh cut the extra off from the bore side, you'd still have a 7 twist at the muzzle

Dam you guys are smart

 

[b6graham]

eh cut the extra off from the bore side, you'd still have a 7 twist at the muzzle

Then you have a 1/2" shank