I want to inlet myself so the closer the current BDL inlet the better. Don't want the Wyatt proprietary mag setup. AI only.
Thanks for any recommendations.
Thanks for any recommendations.
- Thread starter buckbrush
- Start date
i put stiller's in , its a drop in except for width, had to dremmel a bit
The Stiller is great as mentioned.
However, if it's for an aluminum bedding block stock, i.e. B&C or HS, it's A LOT of dremmeling for the width. I did it. I don't recommend it. It takes a mill.
Fiberglass or wood, no problem. Dremmel and a file.
The Stiller is oversize below the stock line and it uses the stock Remington pillar height so minimal fitting.
And it looks cool.
However, if it's for an aluminum bedding block stock, i.e. B&C or HS, it's A LOT of dremmeling for the width. I did it. I don't recommend it. It takes a mill.
Fiberglass or wood, no problem. Dremmel and a file.
The Stiller is oversize below the stock line and it uses the stock Remington pillar height so minimal fitting.
And it looks cool.
