SOLD Wilcox RAPTAR-S FP AB & Wilcox BOSS

[tinycrumb]

Have for sale a fairly special a near-mint condition RAPTAR-S. This was one of the earlier models before they started epoxying the double-screw mount onto the unit. So it comes with 2 mounts, a taller QD mount and an ultra low-profile set-screw mount that is not possible to use with the later epoxied units. You can always epoxy in your own double screw mount if you'd like but the low-profile mount on this is incredibly nice to use and lowers the unit significantly.

This also means you can direct-thread this unit onto your diving boards for the diving boards that support the standard hole with thread pitch. NightForce, KAC and a few other brands do this. I've included a couple photos of 1) on my spotter using the low profile set-screw mount and 2) on my M110 using the direct-thread method onto KAC's diving board.

Otherwise this is standard RAPTAR-S with Applied Ballistics and TRAC-IR support. I've used both with it and the unit works flawlessly. No visible signs of wear on the body or lenses, everything works 100% as it would if it were new. This was used very sparingly (maybe 1 or 2 mags on my M110 and then lived its life on my spotter setup).

Comes with full kit: Original case, cleaning brush, manual, quick-mount cards, CD-ROM, 2 switches (long & short), and both 1913 mounts.

Asking $10k shipped & insured OBO. Can accept most electronic forms of payment. Plenty of feedback available on other well known boards. Can also provide personal references from industry names. Thank you for taking a look!

Up next is a generation 1 Wilcox BOSS 300 Blk optic that was purchased new directly from a Wilcox dealer and has also been sparingly used. Comes with full kit. In near-mint condition, works flawlessly.

Asking $4k OBO.