tikka t3 (not x) hunter. not more than 300r on it. has: limb saver pad,glass bedding,mountain tactical pillars and stainless action screws,mountain tactical steel recoil lug,total of 3 3r mags,rail is either mt tac or egw. barrel is cut to 20 1/2".was going to 20" for blind manuverability but smith couldn't get it there without pulling the barrel. didn't want that done. the little pink tic is @ 20" mark. has allan soft case. pictured midas HMR and rings not for sale at this point. will add to post later if it does get included. no trades. $700 shipped,insured to an FFL that accepts. USPS M.O. only.
no
I only asked because I’ve seen some real abortions from people trying to bed the action after other efforts have failed to remedy accuracy problems. Everything looks fine until you open it up and you understand why they sold it.
this kind of trashing questions should be restricted to PMs for courtesy's sake. but,since not,will say here-pillars and glass done by (IMHO) the best rifle builder in FL. been doing biz with him for 25+ yr. when i got it back did i take it apart and see if he did it right? NO. will i in future? NO. was it inaccurate before? NO. just a bit of improved consistency and more uniform looking groups after. wood stock,so i felt a bit of a hedge for possible bad weather exposure.
Last edited:
up
up
up
pu
up
up
up
up
up
up
up
up
up
