Recent content by rust4brains

I’m at PT, if the description below doesn’t do it I’ll make another attempt later with pictures. First make certain your rifle is unloaded. To adjust below the zero stop you have to move it to the bottom of the range. Make certain the elevation turret is locked. Next locate the 2 screws that...

This request made me curious about my TX6i 3-18x. So this morning while on a work conference call I pulled mine out of the safe to see what the range was. From my zero, I could adjust up exactly 23 MRAD. I then adjusted my zero stop to allow 13 MRAD down. I was then able to go another 12.4...

I don’t have any scopes with issues, however I would not hesitate to send a scope/mount to you if I did. That would be a phenomenal service you would be providing the community.

Great write up sir!!

I now have at least 12 of these throw levers. They are so much more comfortable to grab than the Vortex and switchview levers I have. I've actually broken several of the Vortex levers on 3gun rifles. I have Aadland Engineering levers too, while they are comfortable, they are expensive. These...

Below are the dimensions needed to make a lever. I grabbed this from his website.

Payment sent as agreed in PM's. Thank you sir!!!

Payment sent. Thank you sir.

PM sent

I had to look that one up! You have an excellent vocabulary sir.

Yeah, I have a bunch of various .223’s. But I love shooting my DT. I believe if you sell it you will regret it & the replacement cost will be higher than what you sell it for. Good luck with whatever you decide.

My SAC .223 conversion for my DT SRS A1 is my favorite conversion to shoot. I would be buying this if I didn't already have one!!

Up

Up

I don't have the box handy to get the exact model number. I looked at the stock and the rifle that came out of it. The end of the stock is 18.375" from the rear action screw. The width of the stock channel at the end is 0.960". The barrel at the receiver is 1.235" and the barrel is 0.900" at...