Hodge upper receiver that still needs a forward assist installed. Triarc 13.9” TRACK 2.0 barrel with pinned Triarc gas block and midlength tube. ADM 13” rail. Strike Industries Charging Handle and ADM BCG. No rounds through any of it. FYI, it was a tight fit on my lower. $650 with the BCG/CH or $550 without them.

Payment: PayPal F&F, Venmo F&F, Zelle, CashApp, or Apple Pay.

Trades (+/- Cash):
-A.R.M.S. #22M Rings

150.00 shipped

Going to hit a 22 match for fun this weekend and to stress myself out it's with zero prep. Anyone have a BC for SK Rifle Match or Wolf Match Target? I can confirm velocity when I zero in the morning but before then I'll have zero chance to check anything. I've seen for the most part 0.132 is the best average but saw people using as high as 0.170.

Past velocity:
SK RM: 1003, 74.1es, 18.1sd (20 round string)
Wolf MT: 1083, 28.9es, 8.5sd (20 round string)

My preference is the Wolf MT, been most consistent/accurate but my next best that I have enough of is SK RM.

Selling a new Schmidt and Bender 5-25x56 PMII with DTII+ turrets and H59 reticle. The scope is in flawless condition and will come as shown with scope caps, no factory box.

Link to scope details HERE.

SOLD

No trades please.

Stoopid bitch leaves her gun in the restroom of an arena. The chief says that she's a good girl and will be punished. Punishment entails of being promoted to overseeing the training of other officers.

Selling a like new Vortex Strike Eagle 5-25x56 with the EBR7-C Mrad reticle and turrets. The scope is in near flawless condition and comes as shown with Vortex Pro 1.45” rings and the factory box.

Sold

No trades please.

Brand new in box never opened


Sold shiconus

I planning on picking up a thermal clip on in the next few months.

I’ve been looking at the RH25v2. I see that used UTM-X are selling for not much more than the Infiray.

Does anyone have time behind both of these? How do they compare? Or do they?

I’m concerned mostly with IQ and detection range. Which one supports more mag?

Any other factors to consider to help make the choice?

I’m aware that the UTM is 10 years old and has no warranty support, but maybe it’s less likely to need it?

I was looking into optics options for the barrels from the Armalite Deals thread and noticed this (obvious) glitch on Optic Planet's website.

This same scope is no less than $249.99 anywhere else (namely, Natchez SS).

Obviously $83.99 is a pricing error. Obviously this order will never be fulfilled, right?

I know many have Optics Planet horror stories. They've never done me dirty, and they don't actually charge your account until the item ships. Oh, and it let me use a discount code.

Nothing ventured, nothing gained.

Howdy
Own an 338 RPR since 2019. Over 1200 rounds thru it, accuracy still sub MOA however I am waiting for the barrel's final demise. I see LRI offers a barrel and the recommended tool. Anyone else? Patriot Valley Arms makes a prefit but the RPR receiver is not configurable (AI, SAVAGE among others are available.

My preference is to perform the swap. Already familiar with AI AE and AT.

Thank you

Does anyone know where I can get the spotting scope filter/cover for the Badger SLICK system on a Leupold mk4 60mm spotter? Badger has had them on back order forever.

BNIB Hawkins 1 piece 36mm mount 1.27 height $325 shipped

Hide,

I have a handful of ARs, but looking for which of my two suppressors to put on a .300 Blackout 8.5 inch. I have a TBAC Magnus I run on my bolt guns, and a Huxwrx Flow 7.62 TI that I run on my ARs. However, I have an 8.5 inch AR pistol with a brace/JP captured buffer and adjustable gas block and I’m not sure what to run. It seems the hux may not perform as well with subsonics, so I’m wondering whether I should throw the Magnus on and adjust the gas down.

I could experiment a bit, but figured I’d come to folks with more experience. Rig has a 1x red dot and would just be mostly plinking and some transition drills.

Thanks in advance.

Bnvd 1431 mk2 with 2500 FOM L3 unfilmed 18UM tubes, very clean. 10160 w/ manual gain & carson milspec optics 4 hours run time, clean. Includes remote battery pack. 7900.00 7700.00 shipped still under warranty from Custom Night Vision.


Trades: 4-20 fde nle zco plus cash

Zelle or check
Spec sheets on request.

Looking to grab an RRS BH-55 SCR Ballhead, must be in very good condition, and also have the SC-ARC dual Lever. If you have the BH-55 with a different clamp, the ballhead itself must be the updated rosette version.

Can pay via PayPal FF or Venmo

***FOUND***


Only dealing with members that have a solid feedback. I’ve already caught scammers…

PM me what you got! Thanks!

Anyone have one that they don't want?

Looking for a Proof Carbon Bull contour .224"

16.5" or 20" 1 in 8" Twist Blank.

Not looking for other contours.

Please PM

Thanks, Rhett

Hey guys. I have an Sig Cross and waiting for a new comp profile 308 barrel from Straight Jacket Armory. I am building a steady hunting rifle. I say that because length plays into the equation but weight does not. So the barrel will be 18” long. I have a young son who shot that rifle last deer season in Federal 6.5 creed amd he did well with it. I was wondering, how slow can I safely shoot 308 ammo. I know he won’t shoot over 250 yards and would like to find something lower recoil for him. Looking at MV only, 2,300fps works all the way out to 400 yards.

Used / VG condition. Mounted on a HK VP9L for approximately 650 rnds

No scratches, rubs, etc… Very clean - 100% function / Shipped in Original box

Shipped L48 / Venmo preferred

Thanks for looking

PS - HK base plate available at an additional cost

Wiebad Pump Pillow like new $75

Wiebad Rifle Caddy good condition $60

APA Fat Bastard 6mm 5/8-24 good condition $100

APA Fat Bastard 30 cal 5/8-24 w/ cone of shame like new $130

DFAT 37 w/ adapter rings for Mark 5 56mm and Razor Gen 3 6-36 $80

Safariland Liberator HP 2.0 $200

VLTOR MUR w/ forward assist never used $100

Two Vets The Kit tripod with 44mm ball head new, never used $650

Prices are shipped in the lower 48. PP F&F only

Leupold MK5 HD 7-35 scope w/CCH mils reticle. Just took this on a trade here from an established member, then a black vortex gen3 popped up for sale so now putting this up.

Includes box, papers, sunshade and Leupold caps.

Also includes MPA 20 mpa 1.25" high mount with diving board.

Scope in great shape some minor ring marks.

**$1,750** shipped CONUS. Zelle or venmo only please. Only trade would be a B&T APC 9 with 8.9" barrel.

Character supreme less than a year old. $330 shipped

MDT grip made by 5x5 precision. New not used. Installed and wasn’t for me. $50 shipped

Great condition.
Comes with all factory bushings plus #7 that I got for my Grendel.
Bushings:
3.4.5.7.8.9.10.12.13.18.23

$90 shipped