Looking to commission some gassers and zero a couple bolt guns and work off the tailgate of my truck. Of course I was looking at Rio and Ben Avery etc. to do so also. But would rather visit them with dialed in rifles I think?

I’ve seen some conflicting information regarding fire restrictions around Tanto Natl Forest land per the land management website. A lot of the BLM areas for that matter.

Not asking for anyone’s spot but maybe a tip or two would be cool. Attached is where I was looking via ON X.

North on 17 and around Queen Creek looks like I’d be more likely to see offroad traffic.

The areas I’m familiar with around Tonopah seem to be filled with more permanent residents.

Thanks in advance.

Barrel is brand new, no rounds. Purchased the barrel from Urbanrifleman. Wilson 20" 1/8 twist .750 contour 80 freebore. I have a barrel nut but she ain't pretty, but it works. I'll let it go with it. Asking $485 shipped. Pp ff, venmo,zelle.

300 plus pieces of Original Silver State Armory 6.8 SPC brass.
68 pieces once fired resized etc
75 pieces resized and primed
160 pieces once fired not processed
All have tarnish from storage
Sold

Looking to sell this bad boy. Comes with the box and scope caps, no rings or documents. Scopes in great condition and will upload more pics this evening when I get home. Asking 2500 shipped and insured. (I was sent the wrong color cap, a black one should be here this evening).

Yo!

Boomerang user getting updated and reacquainted. I am a multidisciplinary competitor, and shoot for Ridgeline Defense, Blackarc Munitions, 2AF, and more.

Thanks!

Any info on this: https://www.schmidtundbender.de/en/...cw-DT-II-MTC-LT-ST-II-ZC-LT/16A-911-422-M3-I6

Just curious if others have seen this. At the range yesterday with my new Razor Gen3 and had targets at 400 yards. Set parallax to 400 and it was removed, dot didn’t shift as I moved my head.

But image was not crisp. If I turned parallax knob to best focus, I was on about 120 yards and yes dot did move so parallax was not removed.

Not a huge deal when parallax set correct but would still prefer the crispest image possible when set properly

Hey Hiders,

I have an Area 419 one-piece tactical scope mount for 30mm scope diameter and is 32mm height and 0 MOA. This was mounted to a rifle and a scope for approx 25 rounds at the range. No scratches, dings, or dents. It is basically new. Comes with the box, unused thread locker (I did use my own blue thread locker), and the bit. All the things it usually comes with.

Asking $280 shipped. I accept Venmo and PayPal.

See attached pics.

Leupold VX-6HD 4-24X52 CDS-ZL2 SIDE FOCUS ILLUM. FIREDOT DUPLEX​

Part #
179294

Like new, only used at the range, and I’ve had no issues with it. I’m selling it because I sized down to save some weight. Comes with unknown munitions premier scope rings.

So at SHOT Show I found this company off in the corner of the main hall. I saw the 3 Lug Actions and was super interested. 3 Lug Bolt, Short throw, nice looking 700 footprint, hmm... So they are doing barreled actions, as well as complete builds, but barreled actions in 2025 interest me.

I ordered up a 6.5 Creedmoor, they spun up a Schneider 5P, all the specs on the barrel, then waited on the weather.

As you can see, I dropped it in an AI ATX Chassis, this is the beauty of a barreled action buy, you can put it together or have them do it. With chassis, dropping an action in is a piece of cake. Once I dropped the barreled action into the ATX I zeroed it with some 143gr Norma.

Initial results were great, but I wanted to see which ammo she liked the best.


The Hornady 100gr VT is super interesting to us. The speed is next level, just shy of 3200fps, but in this rifle the downrange results were very good. Normally we see a terrible SD with a round going this fast, the DGW loved it in a lot of ways. The groups were very good, under 5/8ths of inch at 100, and the Speed was on point at 3180fps, however I one box was better than the rest so we went with that load.



This was the Norma 130gr Load which I believe is the best option for a 6.5CM. I think the 130 space is the right space unless you go lighter. The Heavies are good, we shot the heavies, but the heavies are in the air longer, you have to be on your game. Where I see the heavies shine is in really low SD numbers, like less than 5fps, then I see the heavies exceeding the lighter bullet performance.



as I move forward I will bring you the accuracy results and were we are with the DGW Rifle ...

Borka torque driver kit. Came from an estate. See pics. I believe it is all there. 12ga shell shown for size reference. $100 OBO shipped

2x Hoz and Shield +3 Extensions (Installed, Tested, Like New)
2x Anarchy Outdoors +2 Followers (New)
2x Extra Power Springs. (New)

$60 Shipped

CZ 457 22LR Take Off Barrel (1/2x28 Threaded and 20"). This has never been fired unless they shot it at the factory. Bought the rifle new for the action so I don't need the stock barrel. $70tyd.



View attachment IMG_4047.JPG

Putting a waterline on the plates to give you point of aim, point of impact

Something to shoot for, in this case, The Line

New additions for the JAE-G5:
*Extended ARCA rail offers
Increased mounting flexibility
Stability while shooting prone
*Polymer LOP Spacer offers
Custom fit
Consistent shoulder placement

Great condition Vortex Scope rings 30mm and 1.26". $50tyd.

Rem 700 action with wto switchlug
Bartlein 22 inch 22cm 1:7 5/8×24(seamless protector) 300rds
Xcal 20 inch 6.5cm 1:8 5/8×24(seamless protector) 20 rds with wto thread protector on other end
All work done by wto
1200 shipped

A great condition Vortex PST Gen II (5-25x50 FFP and EBR-7C MRAD reticle). Comes with sun shade and throw lever. I sold the rifle and no longer need the scope. These retail for $1k, asking $800.


View attachment IMG_4051.JPG

Three PMAGs made specifically for the Sig Cross. The are two 10rd and one 5rd in excellent condition. I sold the rifle so I no longer need the mags. $60tyd.
View attachment IMG_4143.JPG

Just got the new PH3 and I’m pumped—but I’ve always been a die-hard Spuhr fan. Because of how the rail is CNC’d, I can’t get one of the base screws to seat properly. Should I carefully file it down to make room for the second screw, or just run it with one? Would love to hear from the gear nerds on this one.

Like new. Comes with inline fabrication quick change top plate.
I paid $775.00
Asking for $old shipped
Zelle or Venmo

Have had this in my safe and decided its time to sell it. This gun has been flawless and a joy to shoot just have to many other projects at the moment. Includes the following:
Accuracy International action
Accuracy international Comp trigger-purchased one of the first ones and have put 1000's of rounds through it without a single issue.
Includes 308 bolt face bolt and small firing pin
Vision Chassis with full bridge
Vision aluminum grip panel with thumb rest
AI Bartlein 26inch 6BR Barrel-approximately 2,000 rounds
AI Bartlein 16 inch 6br Barrel-Approximately 2,000 rounds
mdt grip
Folding stock adapter
This does have the quick change barrel
This has been used and shows signs of use, but functions perfectly.
Price is $3350 shipped, buyer covers any payment fees. No trades at the moment

Ruger American predator 204 low round count. Burris scope 4.5-14x42 10round box mag. Magpul stock. Barrel and action painted od green. Can remove paint if you want me to. $450 shipped.