Selling these round butt J-Frame grips and Scorpion polymer holster. The center grip is VZ and the other two are factory rubber grips.

$45 shipped takes the lot.

Selling a handful of optics.

Nightforce ATACR 4-16X42mm Mil-R reticle. Just serviced at NF to get a spec out from the inside the scope. Clean bill of health. Comes with NF cantilever mount. No box, because I thought I would never sell it. Just need some cash.
$1900 shipped.

SWFA SS 10X Mil-Mil with rear focus. Classic SWFA scope. Comes in Burris rings also will come with SWFA cantilever mount.
$210 shipped. SPF

Trijicon SRO with 1MOA dot.
$450 shipped. SPF

Sig Romeo 5 with 2MOA dot.
$100 shipped. Sold

Selling a new Bartlein MOD400-BB barrel in 6mm 1-7.5 twist. The blank is 29" long and is a straight 1.250" taper. Asking $550 shipped.

New, never used. $125 shipped

Used for a few matches, $180 shipped

Seeing if there is any electricians that can answer a question for me. I'm needing to wire in a 240 volt plug for my garage and opened up my breaker panel to make sure I had room for a 60a breaker and I don't think I have any open slots , there does appear to be two on the very bottom of the board but I'm not sure if those are supposed to be left open ?

Assuming my board is full, is the best option to wire in a subpanel?

Thanks in advance

Never mounted or used.
Price: $315 shipped to your door.
Payment by PP F&F or Venmo.

CMP Smallbore (22lr) EIC Competition in San Antonio, TX


For any rimfire enthusiasts in San Antonio and the surrounding area. We are thrilled to announce that the our range is hosting a CMP Smallbore EIC Competition. This is an opportunity to earn Smallbore Prone EIC points, or perhaps you are skilled enough to earn the Gold Medalion?


Match Details & Registration
We're limiting participation to 30 spots to ensure a smooth and enjoyable competition for everyone. You can register electronically via PractiScore or by contacting the Match Director. The links are provided below. If you have any questions at all, please post them, and I will do my best to get you an answer.

EIC Dates:
13 September 2025
8 November 2025

www.stmtc.org

Link to Match Bulletin:

Practi-Score Registration

Scope is in excellent condition, no marks. Comes with box ,papers and ill throw in a set of 34mm warne rings. G4p mil reticle.
Asking $1050 shipped pp ff, venmo,zelle
Trades
Henderson gen 3
Hornady power trimmer
Fx120i
V3 or v4
Swarovski 10x42 slc

Hey all. I was considering getting a YHM R9 to use on my 5" 9mm PCC and 8" 300BO, but after watching a bunch of videos, it seems that everyone is saying that the R45 outperforms the R9 at everything, despite the oversized bore, and it's only an inch longer. I have a bunch of silencers to buy because I'm going to go dedicated on my 5.56 rigs because I shoot those a lot. On the other rigs, swapping cans makes sense.

These are all new and ready for a new home. We have too many. More to come!

Proof CF Blanks --

(2) 104729 - 6mm, 26", 7.5T, Sendero $850 each
(1) 100929 - 6.5mm, 26", 8T, Sendero - $850

Proof Steel Blanks --

(1) 112793 - 6.5mm, 28", 7.5T, M24 - $450

Proof Prefits - Zermatt Origin --

(2) (1) .308, 26" 10T, Stainless Steel, Competition Contour - $650 each
(1) 6mm ARC, 22", Carbon Fiber, Sendero - $1000

Proof Prefits - Zermatt TL3 --
(2) .308, 20", 10T, Carbon Fiber, Sendero - $1000/e

Aero Precision Prefits - Zermatt Origin --
(2) .308, Stainless Steel, Spiral Fluted, 18" - $350/e

We can CERAKOTE these prior to shipping, quite fast, for $85 per barrel. We are a factory trained Cerakote facility.

Plus actual shipping cost. I have a dozen or so other blanks needing homes. I will update the list as I catalog them.

More Blanka Added!!

Bartlein — $450 e/

(1) .22 16T 5 Groove SS 28”
(1) .243 7T 4 Groove SS 29” .91 at muzzle
(1) .243 8T 5R SS 27” .900 at muzzle

Proof SS blank — $450 e/
(1) .243 8T 30” .90 at muzzle
(2) .243 8T 28” .985 at muzzle
(1) .243 8T 28” finish, .995 at muzzle

Members of a known terrorist organization and international gang shot 5 people in December and local talent did nothing and today feds arrested 12 members of said terrorist organization including the 2 wanted for the mass shooting that killed three? Did I get that correct ?
Not one state or local law enforcement agency was willing to to anything , but the feds swept up the entire Clique in a day with no shots fired and recovered several guns and narcotics?



It’s almost like they abandoned their oath, is it out of fear , because of “orders” from in high or was it a business arrangement where they got paid to be strictly hands off?

Eberlestock X1 Euro in excellent condition. No tears or zipper issues. Asking one 50 plus shipping. Great pack, I just have too many.

posted similar before. interested in a lighter weight AR10. what is seen on here and elsewhere is about 20% + on SFAR. not a good gamble. looked at the PSA sabre 308 16". no weight listed. called PSA. after getting a "product specialist" i was told weight empty is 6.8 #s. does anybody have one or know from experience if that is correct?
seems iffy. IMHO if they had a gun that light,seems they would advertise that fact.

I have my ar. Originally built 2010ish and been changing parts out to update it over time. Quad rail is now a strike mlok, comp switched for thunderbeast flash hider to ultra 7 Gen 1. Leupold mark ar 3-9 switched to vortex strike fire to nothing currently but going 2.5-15 direction.

Latest Pic. Vert grip gone, pic rail gone replaced by mdt arca rail this week, strike fire off on something else.


Currently has a 3lb timney competition single stage. Bought it without knowing much. Looking at going more 2 stage cause it would be nice to be able to touch the trigger and know I'm on without it going off.

What do you all use on your more precision type rigs?

Have done some searching in this forum but haven't seen much about some of the options. Triggertech duty vs competitive, timney targa short vs long, or any of the others.

selling a new take off trigger tech primary trigger from my new seekins rifle. No bolt release, $110 shipped

I have 2 of the Burris XTR 2 1-8x24
FFP - MRad
M.A.D knobs
Illuminated Ballistic Circle Dot Reticle
Made in Japan version
Lens caps
Boxes
#201018

One is like new in box with papers

The other is in very good condition in sn aero mount with a homemade throw lever that I can remove if you want.
SOLD Shipped - please specify which one you want



Also have:

XTR 3 3.3-18X50 Sale Pending
FFP - MRad
Illuminated SCR 2 reticle
Made in Phillipines version
 Sunshade
Box
#201204

Just got this from another member and decided to go in a different direction. In very good condition.

 SOLD

Please message me directly. Do not post in thread. I will respond to your message. Available to do phone or video call prior to you sending payment. Beware of scammers.

Various forms of payment available.

This is a variation 2, PMII 6-36 with P5FL reticle in sniper gray. I LOVE this scope but I’m OCD and want a black optic to match my gun lol.

Scope is in good shape with minor ring marks in the finish (the finish isn’t anodized or cerakote so it shows the marks).

$3,200 shipped.

Looking for the following:
- S&B PMII 6-36 with any reticle in black
- ATACR 7-35 w/ MilXT, H59, or T3
- leupold Mark 5 7-35 PR2, H59, or T3
- 1-8 ATACR or NX8 mil

SOLD

Minty fresh condition.

Purchased both new a few months back and it’s just sat on a safe queen.

Vortex Razor 1-6 E MRAD VMR-2
LaRue LT204 C.A.N SPR QD Mount
Vortex SV-3 throw lever

Prices:
Both optic/sv3 and mount - $1050
Optic w/SV-3 - $925
Mount Only - $200

Shipping/Insurance: both included

Mount not for sale until the optic is gone.

Payment: Zelle or Apple Pay

1 sealed can (200 rounds), 1 opened can (150 rounds)
Sealed - $2499 shipped Sold
Opened - $1850 shipped

RUAG ammo 260gr Tungsten Carbide

After (finally) getting some Berger 410s in for my 37XC, I was able to get out to a private range to do an initial test using N570. The issue is that I was unable to find any load data whatsoever. As such, I decided to start a thread here for others who might either be using the 410s in their 37XCs or for those who might be looking for information.

For my first foray, all I had to go on was my limited exploration of 390 ATips - my entire previous experience had been with much lighter bullets (Lehigh 353s). With the Lehighs, I had gotten decent results with H1000, but I think that such a speed powder would be too fast for a bullet weighing 57 grains more. With the ATips, I used 120gr of N570 and it seemed to do okay for the limited amount of time I tried that bullet.

For the 410s, I decided to do a shortened ladder starting at 114.5gr and going up at 1gr increments so I could attempt to find pressure. I also loaded up 6 foulers - 3 at 116gr and 3 at 117gr.

Here is the average velocity for each of these charge weights:

Temp: 85 F Humidity: 30%
Seating depth (essentially randomly chosen): .020"
4 shots each, except for the two fouling loads (116 and 117), which were 3 each.

114.5gr 2849 fps
115.5gr 2873 fps
116gr 2873 fps
116.5gr 2886 fps
117gr 2900 fps
117.5gr 2920 fps - very slight heavy bolt lift
118.5gr 2935 fps - heavy bolt lift
119.5gr Loaded, but did not fire due to pressure at 118.5

Here are the groups - not that I was shooting for groups, but it's interesting to see. Of note, the lower end of the ladder felt like big heavy pillows pushing me back. At the higher end, it was hard recoil - and my shoulder started to hurt. I'm likely going to play in the 116 to 117 range.

Also note that this was a reused target - disregard the Shoot n' See targets on the lower left.



Here's the rifle:

New in box. Geissele smr mk18 arca rail 16.5 with barrel nut wrench. $275 shipped. Zelle or MO.
Thanks.

No matter how many crimes they commit or how severe



On video helping an illegal invader - woman and child abuser escape federal detention- and they are calling for judicial immunity. This sounds vaguely familiar- seems there is another related group that claims immunity ALOT no matter how terrible or inexcusable the act they commit .

KAC SR-15 16” Upper

Around 300 rounds fired and works flawlessly. Selling without front and rear micro sights.
$1400 shipped and signature required.