Swapping recoil pads

[Dot3]

I’m looking to shorten LOP on a B&C target/varmint stock with a half in pachmayr pad. Anyone know which model is supposed to fit? RP200 is a grind to fit but how about hole spacing?

 

[Baron23]

I’m looking to shorten LOP on a B&C target/varmint stock with a half in pachmayr pad. Anyone know which model is supposed to fit? RP200 is a grind to fit but how about hole spacing?

I’m fairly sure that they have drawings on their site showing the hole pattern. Just see if it matches the pattern in your stock.

I suspect they are the same.

 

[Dot3]

I’m fairly sure that they have drawings on their site showing the hole pattern. Just see if it matches the pattern in your stock.

I suspect they are the same.

I quit google a long time ago and the Brave search engine isn’t in the same league as far as capability. Didn’t see their site but will dig deeper. Thank you

 

[Baron23]

I quit google a long time ago and the Brave search engine isn’t in the same league as far as capability. Didn’t see their site but will dig deeper. Thank you

3.12" (3 1/8") center to center hole pattern is what Pachmayr uses on their medium and large grind to fit pads. That is also the hole pattern used by Kick-eez. Limbsaver doesn't say...they just provide "templates" that you are supposed to print off and use. Fuck that...if they don't publish their data, then I don't use their pad.

As for fit....get a grind to fit and almost any gunsmith/stock guy can easily grind a pad to fit...if you are handy at all with tools, you can do it yourself.

Pachmayr's install dimensions

 

[Dot3]

Beautiful! Thank you

 

[pineoak]

I quit google a long time ago and the Brave search engine isn’t in the same league as far as capability. Didn’t see their site but will dig deeper. Thank you

try duckduckgo