SH hello everyone,
I am honestly hoping I am pulling a Newbie mistake and I haven't got a problem. SO My new scope is in ! Got it leveled mounted love it!. Went to bore sight it and got it done then to move those turrets back to zero I noticed that they were already 2 revolution hashes high.... dialed it all the way down and the mil quad reticle confirmed it took 10 mills up to bore sight, cool. SOOOOO my question. now that I boresighted it how do I get the turret back to the 1st revolution hash mark since starting on the 3rd hash would deafeat the purpose of knowing which revolution your on. Yes I made sure to looken all the allen screws plenty so it was not touching the internal copper stud. But it simply will not go down..... I quit trying to figure it out less I brake somthing. Anyone can ya help
I am honestly hoping I am pulling a Newbie mistake and I haven't got a problem. SO My new scope is in ! Got it leveled mounted love it!. Went to bore sight it and got it done then to move those turrets back to zero I noticed that they were already 2 revolution hashes high.... dialed it all the way down and the mil quad reticle confirmed it took 10 mills up to bore sight, cool. SOOOOO my question. now that I boresighted it how do I get the turret back to the 1st revolution hash mark since starting on the 3rd hash would deafeat the purpose of knowing which revolution your on. Yes I made sure to looken all the allen screws plenty so it was not touching the internal copper stud. But it simply will not go down..... I quit trying to figure it out less I brake somthing. Anyone can ya help