Suppressors Any way to get an Omega to fit a 1/2x32 threaded barrel?

[calvert]

I have a couple of Silencerco Omegas. Now I have 2 Gap rifles with 1/2x32 threaded barrels. Only harvester has a direct thread backplate in that size but I believe it
doesn't fit the Omega. Unable to get response from Silencerco. Any suggestions would be appreciated.
thanks

 

[2ndamendfan]

If your just looking at their website, personally it is a mess for accessories. I had to call on my hybrid to get the part numbers that would work. Call them they are good to help.

 

[spife7980]

Yeah, I use a 1/2x28 5.56 asr brake and the omegas come with the asr module already so you just have to buy the brake. When I got mine I also got a free device with registration so I got it included that way.

theres also the 419 hellfire brake that can mount an omega I think.

 

[smokin.338]

Think your best bet is something like this: https://precisionarmament.com/product/m4-shoulderless-thread-adapter/
And then covert it back to 5/8 x 24 for a muzzle device...

 

[Forward543]

Call silencerco. They have been very helpfull when i needed their help. You could also have your gun re crowned and a 1/2 28 thread put on it. Should cost $80-$100

 

[flyer1a]

Yeah, I use a 1/2x28 5.56 asr brake and the omegas come with the asr module already so you just have to buy the brake. When I got mine I also got a free device with registration so I got it included that way.

theres also the 419 hellfire brake that can mount an omega I think.

That Area 419 Omega mount is now available, check it out

 

[craigos]

you can get a 1/2x32 to 5/8x24 here (http://www.precisionreflex.com/Detail.aspx?PROD=186808) ...