Specifically on a McMillan stock? How long does it take? Is .100" on the diameter a lot to remove?
Gunsmithing Has anyone opened up a barrel channel?
- Thread starter Undrgrndprdcts
- Start date
Not too bad. I used a deep socket and 40 grit sandpaper.
I did it with sandpaper and just kept tightening the action and barrel down to ensure i got the clearance needed on my rifle
I did a Manners carbon fiber stock with a closet rod dowel wrapped in sandpaper- it came out really well and I just used a black sharpie to make the sanded areas look the same as the rest of the barrel channel.
Not really. 40 or 60 grit will get you there very quick. It's just fiberglass.
The edge of the barrel channel is glassed, the majority of the channel is some sort of "surfboard" foam that sands pretty quick.
While we are at it, what is the thinnest forend you would use for a bartlein 3b or Krieger #5 ish contour?
Has anyone opened up a barrel channel?
Thousands of them.
- Thread starterUndrgrndprdcts
- Start dateYesterday at 4:10 PM
Thousands of them.
Last edited:
Chad:
Who performs the background music? A link to a CD would be greatly appreciated.
Thanks, C.S.
I opened up mine after it failed the dollar bill test.. ran a dollar bill down the length of the barrel and it kept hanging up in a couple of spots.. I took the barreled action out and wrapped 60 grit sandpaper around a 7/8" dowel.. finished it up with 220 until nice and smooth.. a little matte black spray paint and finished the job up.. looks factory, and now the barrel is completely free floated.. all said and done, it took about an hour..
60 grit sheet of sand paper with the barrel in stock and just let the sand paper wrapped under the barrel face down and then grab the ends of the sand paper and work it back and forth. This will give you very good results so your stock matches the contour of your barrel.
Similar threads
