What height rings for BMR

[BKSSNIPER]

I’m going to put a 30mm scope with a 50mm objective on my BMR carbon. A Vortex Strike Eagle
What heights rings?
Sorry if this has been covered and I didn’t find it.

 

[IamJoHo]

You should be able to get the Vortex low rings to fit.

 

[Rob01]

Something in the .92" height range will work. I wouldn't go lower especially with the appearance of a lower mount on the BMR.

 

[Defender32]

I stay with .94 or 1.1 most of the time. I prefer the ARC M10 rings.

M10 Scope Rings

www.americanrifle.com

 

[143lrsd]

I stay with .94 or 1.1 most of the time. I prefer the ARC M10 rings.

M10 Scope Rings

www.americanrifle.com

They also have a very simplistic way to calculate what height of rings to buy.

 

[AZ Dan]

0.92" rings work with my Arken SH4, but I have the steel barrel, which is tapered. And I mean the BARELY work...I have to measure the barrel/scope gap with a feeler gauge. It would never work with the straight taper "carbon" barrel.

I always use this calculator for determining ring height;

Scope Ring Height and Clearance Calculator

 

[coontz74]

Strike Eagle 5-25x56 FFP

Please Select Reticle | 34mm Tube

vortexoptics.com

If this is the model you are looking at, then may reconsider height given this is a 34mm tube with 56mm objective. As said above, maybe use the calculator…

 

[BKSSNIPER]

The scope is a Vortex Strike 4x24x50. Model number is SE1627 I think.
They are on clearance for 299.99 at Europtic

This is what I wound up with. There is less than 1/8 inch clearance with barrel. Just enough for flip up caps.