• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Recent content by captbutch

  1. C

    Quick Load ??

    I have an Oehler coming this week, but I pretty sure it's right.
  2. C

    Quick Load ??

    Yes to all that...
  3. C

    Quick Load ??

  4. C

    Quick Load ??

    Working with load data and trying to understand why predictions are not close to actual. I'm loading this as pictured but actual velocities are almost 200 fps faster than quickload. 62.5 gr H1000 3246 fps avg 16 ES 8 SD What am I missing here? Cartridge : 6.5 mm RSAUM Bullet : .264, 123...
  5. C

    6.5 SAUM trim length

    I believe 2.025 is the trim length most used...
  6. C

    Leica 1600-b 300.00TYD

    I'll take it for $300.00 Shipped.
  7. C

    IMR 8133 QuickLoad profile

    Seems to be near Retumbo burn rates
  8. C

    IMR 8133 QuickLoad profile

    It's not in the powder profiles yet...
  9. C

    IMR 8133-6.5 saum...

    Hornady brass, ? # times fired but primers were tight when loaded. 6.5 Saum .081 freebore...
  10. C

    IMR 8133-6.5 saum...

    Hornady brass, 210 Fed primers, 139 Scenars
  11. C

    IMR 8133-6.5 saum...

    I did Chrono all loads from the start. Went from 2830 to 3179 at 66 gr. 64.5 grain loads averaged at around 3100, which is still below what I was getting with H1000.
  12. C

    IMR 8133-6.5 saum...

    Well I started at 58 gr 8133 worked up to 65.5 a half grain at a time no pressure signs at all, 66gr blew a primer...So I dropped back to 64.5 gr, first two no problem third blew another primer! All pockets were tight when seated...Accuracy was 1 hole at 130 yds with the 64.5 gr load...Any clues?
  13. C

    IMR 8133-6.5 saum...

    Thanks to all who replied, I'll give it a go...
  14. C

    IMR 8133-6.5 saum...

    Anyone using this powder in the 6.5 saum? Just picked some up and looking for a place to start.
  15. C

    Drill adapter for RCBS Trim Pro 2

    I just remove the hand crank and insert the shaft in my drill and tighten. Seems to work fine...So what is the need for an adapter? Am I missing something here?
See more
Top Bottom
Back
Home
Forums
Merch
Alerts